Differences

This shows you the differences between two versions of the page.

--- switch_or_ap_mode [2026/07/27 17:35] – [Configure Access Point mode] Formatting-make steps numbered bullets hogwild
+++ switch_or_ap_mode [2026/07/27 17:39] (current) – [Configure Access Point mode] -format hogwild
@@ Line 23: / Line 23: @@
   * Add the WAN port to the LAN FIXME
-\\ Next, connect an Ethernet cable to any LAN port on each router. This will create a LAN-to-LAN connection. On the router acting as a switch, you can connect the cable to the WAN port, but only if that port has been reassigned to the LAN bridge.
+\\ \\
+Next, connect an Ethernet cable to any LAN port on each router. This will create a LAN-to-LAN connection. On the router acting as a switch, you can connect the cable to the WAN port, but only if that port has been reassigned to the LAN bridge.
  \\
@@ Line 34: / Line 36: @@
 ===== Configure Access Point mode =====
-  - First, configure the router as a switch using the above instructions. \\ \\
+  - Follow the steps above to configure the router as a switch. \\ \\
+  - Next, in the /Basic/[[basic-network|Network]] menu, simply add an Access Point \\ as you normally would. FIXME \\ \\ Additional APs can be added as virtual interfaces in the \\ /Advanced/[[virtual_wireless|Virtual Wireless]] menu. Ensure all ports and all \\ wireless interfaces are assigned to the same bridge (e.g. br0) \\ in  the /Advanced/[[advanced-vlan|VLAN]] menu.
-  - Then, in the /Basic/[[basic-network|Network]] menu, simply add an Access Point \\ as you normally would. Additional APs can be added as virtual interfaces in the /Advanced/[[virtual_wireless|Virtual Wireless]] menu. Ensure all ports and all wireless interfaces are assigned to the same bridge (e.g. br0) in  the /Advanced/[[advanced-vlan|VLAN]] menu.
  \\

FreshTomato Wiki

User Tools

Site Tools

Differences

Page Tools