User Tools
switch_or_ap_mode
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| switch_or_ap_mode [2026/07/27 17:16] – [Use a router as a switch or Access Point] hogwild | switch_or_ap_mode [2026/07/27 17:39] (current) – [Configure Access Point mode] -format hogwild | ||
|---|---|---|---|
| Line 23: | Line 23: | ||
| * Add the WAN port to the LAN FIXME | * Add the WAN port to the LAN FIXME | ||
| - | \\ Next, connect an Ethernet cable to any LAN port on each router. This will create a LAN-to-LAN connection. On the router acting as a switch, you can connect the cable to the WAN port, but only if that port has been reassigned to the LAN bridge. | + | \\ \\ |
| + | |||
| + | Next, connect an Ethernet cable to any LAN port on each router. This will create a LAN-to-LAN connection. On the router acting as a switch, you can connect the cable to the WAN port, but only if that port has been reassigned to the LAN bridge. | ||
| \\ | \\ | ||
| - | On both routers, check that every port is assigned to the same bridge (e.g. " | + | Finally, on both routers, check that every port is assigned to the same bridge (e.g. " |
| \\ | \\ | ||
| Line 34: | Line 36: | ||
| ===== Configure Access Point mode ===== | ===== Configure Access Point mode ===== | ||
| - | First, | + | - Follow the steps above to configure the router as a switch. |
| + | - Next, in the / | ||
| \\ | \\ | ||
switch_or_ap_mode.1785168999.txt.gz · Last modified: by hogwild
Page Tools
