Site Tools


admin-access

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
admin-access [2024/11/28 23:09] – [SSH Daemon] -punctuation hogwildadmin-access [2024/11/28 23:13] (current) – [Admin Restrictions] -Formatting hogwild
Line 159: Line 159:
 **Stop Now/Start Now:** clicking this instantly stops/starts SSH, whichever is the opposite of its current state. **Stop Now/Start Now:** clicking this instantly stops/starts SSH, whichever is the opposite of its current state.
  
-The button will display its current state, and later the opposite option after you click on it. The SSH daemon will start again at next bootup (if //Enable at Startup// is enabled).+The button displays its current state, and then the opposite state after you click on it. SSH will start again at next bootup (if //Enable at Startup// is enabled).
  
  
Line 185: Line 185:
 ===== Admin Restrictions ===== ===== Admin Restrictions =====
  
-**Allowed Remote IP Address:** the IP addresses/ DNS names of hosts to allow to connect to the FreshTomato web interface.+**Allowed Remote IP Address:** the IP addresses/DNS names of hosts to allow to connect to the router'web interface.
  
 Addresses can be individual, comma-separated, or a dash-separated range, ("1.1.1.1-2.2.2.2"). The setting applies to local and remote administration via HTTP, HTTPS, SSH (if enabled) and Telnet (if enabled). Addresses can be individual, comma-separated, or a dash-separated range, ("1.1.1.1-2.2.2.2"). The setting applies to local and remote administration via HTTP, HTTPS, SSH (if enabled) and Telnet (if enabled).
Line 191: Line 191:
  \\  \\
  
-**Limit Connection Attempts: ** specifies whether the number of SSH or Telnet connection attempts will be limited to number (n) at certain frequency (f). (Default: 3 connection attempts every 60 seconds).+**Limit Connection Attempts: **specifies whether the number of SSH/Telnet connection attempts will be limited to number (n) at certain frequency (f).
  
-Checking SSH limits the number of SSH connection attempts to number n at frequency f (in seconds). Checking Telnet works similarly.+(Default: 3 connection attempts every 60 seconds). Checking SSH limits the number of SSH connection attempts to number n at frequency f (in seconds). Checking Telnet works similarly.
  
  \\ {{::administration-admin_access-admin_restrictions-2024.3.png?688}}  \\ {{::administration-admin_access-admin_restrictions-2024.3.png?688}}
admin-access.1732835397.txt.gz · Last modified: 2024/11/28 23:09 by hogwild