Differences

This shows you the differences between two versions of the page.

--- admin-access [2024/11/28 23:07] – [SSH Daemon] -Condense hogwild
+++ admin-access [2024/11/28 23:13] (current) – [Admin Restrictions] -Formatting hogwild
@@ Line 159: / Line 159: @@
 **Stop Now/Start Now:** clicking this instantly stops/starts SSH, whichever is the opposite of its current state.
-The button will display its current state, and later the opposite option after you click on it. The SSH daemon will start again at next bootup (if //Enable at Startup//) is enabled.
+The button displays its current state, and then the opposite state after you click on it. SSH will start again at next bootup (if //Enable at Startup// is enabled).
 ===== Telnet Daemon =====
-(Terminal EmuLation over the NEtwork) is a protocol which allows LAN and remote connections via a command-line interface. Unlike SSH, Telnet is not a secure protocol.
+The (Terminal EmuLation over the NEtwork) protocol allows LAN and remote connections via a command-line interface. Unlike SSH, Telnet is not secure.
  \\
@@ Line 185: / Line 185: @@
 ===== Admin Restrictions =====
-**Allowed Remote IP Address:** the IP addresses/ DNS names of hosts to allow to connect to the FreshTomato web interface.
+**Allowed Remote IP Address:** the IP addresses/DNS names of hosts to allow to connect to the router's web interface.
 Addresses can be individual, comma-separated, or a dash-separated range, ("1.1.1.1-2.2.2.2"). The setting applies to local and remote administration via HTTP, HTTPS, SSH (if enabled) and Telnet (if enabled).
@@ Line 191: / Line 191: @@
  \\
-**Limit Connection Attempts: ** specifies whether the number of SSH or Telnet connection attempts will be limited to number (n) at certain frequency (f). (Default: 3 connection attempts every 60 seconds).
+**Limit Connection Attempts: **specifies whether the number of SSH/Telnet connection attempts will be limited to a number (n) at certain frequency (f).
-Checking SSH limits the number of SSH connection attempts to number n at frequency f (in seconds). Checking Telnet works similarly.
+(Default: 3 connection attempts every 60 seconds). Checking SSH limits the number of SSH connection attempts to number n at frequency f (in seconds). Checking Telnet works similarly.
  \\ {{::administration-admin_access-admin_restrictions-2024.3.png?688}}

FreshTomato Wiki

User Tools

Site Tools

Differences

Page Tools